Характеристики и описание
Mechanical values and environment | |
|---|---|
| Design | B |
| Material | |
| Cable material | PVC |
| Housing material | Fiber glass reinforced PPS |
| Weight | |
| Net | 0,16 kg |
| Ambient temperature | -20 ... 60 °C |
| Degree of protection | IP67 |
| Installation position | Any, pay attention to marking During mounting it is to be ensured the marking arrows on actuator and read head are opposite each other. |
| Tightening torque | 0,4 ... 0,5 Nm |
| Number of NO contacts | 2 NO contacts with internal fuse 100 mA each |
| Connection | Hard-wired encapsulated cable with cable end sleeves 0.34mm2 |
| Cable length | 3 m |
| Mechanical life | 100 x 106 |
| Method of operation | Magnetic, reed contact |
Electrical connection ratings | |
| Rated conditional short-circuit current | 100 A Parameter dependent on the evaluation units ESM-BA2.. and ESM-BA3.. |
| Fusing | |
| Power supply / safety contacts, external contact protection | Fuse 10 A gG Parameter dependent on the evaluation units ESM-BA2.. and ESM-BA3.. |
| Switching voltage | 24 ... 35 V |
| Switching current | max.100 mA |
| Switching characteristics | Parallel |
| Switching voltage according to UL | |
| According to UL Class 2 | AC/DCmax.24 V |
| Switching frequency, electrical | |
| At I_min = 10 mA | max.5 Hz Parameter dependent on the evaluation units ESM-BA2.. and ESM-BA3.. |
| At nominal current 8 A | max.0,1 Hz Parameter dependent on the evaluation units ESM-BA2.. and ESM-BA3.. |
| Switching delay from state change | 26 ms Parameter dependent on the evaluation units ESM-BA2.. and ESM-BA3.. |
Miscellaneous | |
| in compliance with | EN ISO 13849-1: 2015{} EN 62061: 2005 + AC: 2010 + A1: 2013 + Или отправьте нам запрос на13{} IEC 60947-5-3: 2013 |
Reliability values acc. to EN ISO 13849-1 | |
| Monitoring of the safety guard position | |
| B10D | 20 x 106 |
in combination withEvaluation unit ESM-BA201, ESM-BA202, ESM-BA203, ESM-BA301, ESM-BA302, ESM-BA303, ESM-BA201P, ESM-BA301PandActuator CMS-M-BH | |
| Center offset | |
| At s=3 mm read distance | 2,5 mm Figure only applies if there is no ferromagnetic material in the vicinity of the read head and the actuator. |
| Assured switch-off distance Sar | max.20 mm The assured switch-off distance s_ar corresponds to the reset distance. |
| Assured operating distance Sao | |
| With center offset m=0 | min.7 mm Figure only applies if there is no ferromagnetic material in the vicinity of the read head and the actuator. |
Mechanical values and environment
По вопросу интересующей Вас продукции, пожалуйста, свяжитесь с нами:
8 (029) 555-8-000 | |
8 (044 |
Доставка
Оплата и гарантии